RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Heli-NuBee
Showing results 1 to 19 of 19
Search took 0.02 seconds.
Forum: Gas Engines
10-24-2015, 08:23 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

http://www.rcuniverse.com/forum/attachment.php?att...

http://www.rcuniverse.com/forum/attachment.php?attachmentid=2127318http://www.rcuniverse.com/forum/attachment.php?attachmentid=2127319http://www.rcuniverse.com/forum/attachment.php?attachmentid=212732...
Forum: Gas Engines
09-11-2014, 03:00 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I had my maiden flight today using the NGH 38GF...

I had my maiden flight today using the NGH 38GF engine on my GP Super Sportster. The engine ran very well and flew the plane just fine. However, three of the four engine mounting bolts were loose...
Forum: Gas Engines
09-09-2014, 08:42 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I used red locktight on the engine bolts that...

I used red locktight on the engine bolts that came loose and let it cure for a full day. I then ran the engine again and did some additional tuning. The engine is running much better now but still...
Forum: Gas Engines
09-05-2014, 02:36 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I did a test run on the NGH-38GF engine powered...

I did a test run on the NGH-38GF engine powered GP Super Sportster today. I got the engine running much better. The low needle was quite rich and tuning helped the low end shaking. However, the...
Forum: Gas Engines
09-02-2014, 12:49 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

OK, it is time to move on. I am now installing...

OK, it is time to move on. I am now installing my NGH 38 GF engine in my GP Giant Super Sportster. I will post additional details and pictures in the near future.

Best wishes and good safe...
Forum: Gas Engines
08-29-2014, 05:57 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I had my maiden flights on the 109 Wednesday...

I had my maiden flights on the 109 Wednesday morning. The plane flew very well and the engine ran great. The only issue encountered was the tendency for the landing gear to bounce if one trys to turn...
Forum: Gas Engines
08-26-2014, 09:49 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Just a quick update - I installed a Dave Platt...

Just a quick update - I installed a Dave Platt spinner on the NGH 35 and did a bit more tuning while completing additional break-in engine runs. The engine now runs much smoother and my CMP BF-109...
Forum: Gas Engines
08-08-2014, 05:52 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I checked into RC Japan and their price seems...

I checked into RC Japan and their price seems pretty good until you get the shipping and the 3.5% fee for using a credit card or Pay Pal. The only advantage to purchasing from them would be for...
Forum: Gas Engines
08-07-2014, 04:43 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Thanks SrTelemaster150 - I will look into RC...

Thanks SrTelemaster150 - I will look into RC Japan.

Best wishes and good safe flying.

Heli-NuBee (AKA Roger the radial rabbit)
Forum: Gas Engines
08-06-2014, 06:08 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

OK guys, thanks for the suggestions but I have...

OK guys, thanks for the suggestions but I have previously posted that I gave away a Saito 180 because it had too much vibration and was damaging the airframe. Saito's have a good reputation and I...
Forum: Gas Engines
08-05-2014, 02:53 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Update, I replaced my NGH 38GF four-stroke engine...

Update, I replaced my NGH 38GF four-stroke engine in my CMP BF-109 with an NGH 35GX two-stroke engine due to excessive vibration. The new NGH 35 CC engine runs great but also has a lot of vibration....
Forum: Gas Engines
07-28-2014, 06:28 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

My replacement engine arrived today. I purchased...

My replacement engine arrived today. I purchased an NGH 35 CC rear exhaust two-stroke engine to replace the 38FG. The 35 has both rail and back plate mounting and can be side or rear exhaust. I...
Forum: Gas Engines
07-28-2014, 09:07 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Thanks guys for your input. It is a CMP BF-109...

Thanks guys for your input. It is a CMP BF-109 and the motor mounts are less than stellar. After some consideration, the engine ran well but with a lot of vibration. I think I will try it on...
Forum: Gas Engines
07-24-2014, 01:24 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I ran my NGH-GF-38 engine for the first time...

I ran my NGH-GF-38 engine for the first time today. The engine ran well but shook very hard. It shook so hard that it broke the motor mounts and the throttle linkage. This engine is not for me and...
Forum: Gas Engines
07-23-2014, 11:54 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

OK, does anyone else think that we have lost the...

OK, does anyone else think that we have lost the purpose of this forum? Sorry guys, but I have had good and bad cheap engines and good and bad expensive engines. I don't think we can ever solve...
Forum: Gas Engines
07-22-2014, 05:56 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Hey guys, I am nearing completion of my CMP...

Hey guys, I am nearing completion of my CMP BF-109 that will be powered by an NGH-GF-38 engine. I previously had an NGH 15 CC engine with very good results. There was a lot of negative info posted...
Forum: Gas Engines
03-16-2014, 02:22 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

Thanks for sharing the pics tyor. My NGH GF38...

Thanks for sharing the pics tyor. My NGH GF38 will probably end up in my CMP 71" BF109. Looking forward to your videos.

Best wishes and good safe flying.

Heli-NuBee (AKA Roger the radial...
Forum: Gas Engines
03-05-2014, 08:04 AM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I received my NGH GR-38 last night and it looks...

I received my NGH GR-38 last night and it looks good with no damage. I am looking forward to trying this engine. I may change my mind and install this engine in my CMP 73" BF-109. It should be a...
Forum: Gas Engines
02-23-2014, 06:43 PM
Replies: 1,678
Views: 463,117
Posted By Heli-NuBee

I just ordered a NGH-GF38 engine. I plan to...

I just ordered a NGH-GF38 engine. I plan to install it in my GP Giant Super Sportster. The Sportster calls for a 33 cc engine. I hope this is a good match.

Best wishes and good safe flying.
...
Showing results 1 to 19 of 19


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.