RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 3
1
2
3
Search: Posts Made By: KC36330
Showing results 1 to 25 of 60
Search took 0.05 seconds.
Forum: RC Jets
05-15-2012, 07:04 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

that's a negative, it's the bypass, i installed cams to find the source.
Forum: RC Jets
05-15-2012, 04:14 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

Doug,

i tucked a 170 in my classic, fully bypassed w/ fod screen and while there is minimal space around the turbine it runs great, no overheating problems. at top speed it does cause the...
Forum: RC Jets
03-22-2012, 08:52 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

I've always used em but, i know a few people who haven't and they've had no issues with cooling in the tail, Saunders claimed to have had hundreds of flights without them and no issues.
Forum: RC Jets
02-13-2012, 03:19 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

the glow plug insert sets that distance, if you have the temp probe at 12 o'clock just push the turbine as far forward in the clamp as it will go.

no spacers used.
Forum: RC Jets
02-13-2012, 02:43 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

It's awesome!!!! I thought my Titan SE was fast, the 170 is very niticiably faster.
Forum: RC Jets
02-13-2012, 02:34 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

you always need to have the temp probe at 12 o'clock, it's especially important on a kerosene start for optimal temp detection by the ECU during the start so the ramps happen at the right time.
Forum: RC Jets
02-13-2012, 02:22 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

ORIGINAL: Ramz

Anybody have any pictures of a K170F in a UF? How far should the most rearward part of the exhaust cone of the turbine be from the front of the inner thrust tube? I am trying...
Forum: RC Jets
02-12-2012, 07:19 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

i made them, but i think Todd has premade at dreamworks.
Forum: RC Jets
02-03-2012, 12:00 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

Douggie it's all bout what you see when the hood is closed and the throttle is open!!
Forum: RC Jets
02-03-2012, 08:01 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

any light gray primer for the base coat, then put a light coat of the textured (and i mean light, this stuff is heavy).
Forum: RC Jets
02-03-2012, 07:31 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

i don't plan to make inside (or outside) repairs, but if i should have to i'd sand the inside area to be repaired and glass over it, then repaint.
Forum: RC Jets
02-03-2012, 06:57 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

some people scuff, i just cleaned mine good with alcohol and painted it, no problems at all.
Forum: RC Jets
02-01-2012, 07:35 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

for single channel you just change it to your desired switch.
Forum: RC Jets
02-01-2012, 05:25 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

it's right there 4 posts above your own..........
Forum: RC Jets
01-31-2012, 07:29 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

in gear down position the valve can be overdriven into the breaks on position, you use a mix between the desired channel and gear, and set it to only work in gear down position.
Forum: RC Jets
01-29-2012, 06:17 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

rattle cans if you are using the textured paint, then mask and paper the outside, make sure you seal up the saddle area when spraying the cockpit so over spray doesn't get anywhere you don't want it.
Forum: RC Jets
01-10-2012, 07:18 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

Mike, the conformals are a very snug fit and once the wings on, they can't go anywhere.
Forum: RC Jets
01-10-2012, 05:21 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

Rob, make sure you check the wing bolt length to be sure they don't punch through your tanks.
Forum: RC Jets
01-09-2012, 03:46 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

36 is tight but doable, 48 is a little long.......any option to make your own?
Forum: RC Jets
01-02-2012, 07:17 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

come on Mike, let's not start another JR v/s Futaba debate........ [8D]
Forum: RC Jets
01-02-2012, 07:09 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

You're welcome, i left out..........don't forget to neutralize the trims in the flight modes after you add the mix.
Forum: RC Jets
01-02-2012, 07:02 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

Ali, to fix the ballooning............ on the 12x if you use the servo slow feature on the flaps, the trim change is instant IF you use individual trims in flights modes and that gives you the...
Forum: RC Jets
01-01-2012, 09:04 AM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

i've seen the JetCat version, it was $750 :( not practical for my budget.

Spektrum has 'announced' that they are releasing a telemetry system that interfaces with the JetCat ECU, but that's...
Forum: RC Jets
12-28-2011, 04:23 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

powerbox sensor is plenty for the Flash. careful with too much flap though, the Ultra is a little more forgiving to flap then the Classic but neither like excessive amounts.
Forum: RC Jets
12-26-2011, 02:26 PM
Replies: 6,824
Views: 1,674,193
Posted By KC36330

RE: C-ARF Ultra Flash build Thread + Video

i pull most of the power out on a turn to upwind (this bleeds speed quick), then drop the gear and do a gear pass, use less then 1/4 throttle to turn out and downwind, drop to take off flap on the...
Showing results 1 to 25 of 60
 
Page 1 of 3
1
2
3


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.