RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: hyman
Showing results 1 to 5 of 5
Search took 0.04 seconds.
Forum: RC Jets
04-06-2011, 01:02 PM
Replies: 6,824
Views: 1,674,099
Posted By hyman

RE: C-ARF Ultra Flash build Thread + Video

Gus, I used 8411 on the elevators and I'll be using 8511 on all the rest. Thanks
Forum: RC Jets
04-06-2011, 02:52 AM
Replies: 6,824
Views: 1,674,099
Posted By hyman

RE: C-ARF Ultra Flash build Thread + Video

I shaved down the servo mounting plates on the elevator servo and now its flush on the servo. It still touches the inside of the stab, shall I sand off a little off the inside of the stab?
Forum: RC Jets
03-31-2011, 04:19 PM
Replies: 6,824
Views: 1,674,099
Posted By hyman

RE: C-ARF Ultra Flash build Thread + Video

Dave you're probably right about the tail cone, i'll try this setup and see how it goes coz
Forum: RC Jets
03-30-2011, 10:41 PM
Replies: 6,824
Views: 1,674,099
Posted By hyman

RE: C-ARF Ultra Flash build Thread + Video

Dave the inner thrust tube is in the bellmouth 10 mm as mentioned and the bell mouth is flush on the bulkhead
Forum: RC Jets
03-30-2011, 04:51 AM
Replies: 6,824
Views: 1,674,099
Posted By hyman

RE: C-ARF Ultra Flash build Thread + Video

Hello everyone,

In the manual its mentioned that I need to get the inner thrust tube to at least 8 mm to the outer thrust tube. To acheive that I need to insert the pipe into the bell mouth only...
Showing results 1 to 5 of 5


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.