RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: MomoBrut
Showing results 1 to 7 of 7
Search took 0.01 seconds.
Forum: RC Jets
11-26-2020, 05:11 AM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

Today I spent another two hours testing, this...

Today I spent another two hours testing, this time I also took an oscilloscope. I figured out why it was confusing yesterday that the s.bus output was not always on both ports 5 and 6, and most...
Forum: RC Jets
11-25-2020, 05:42 AM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

BTW, your picture is an old version of CP manual....

BTW, your picture is an old version of CP manual. And I am looking for answers, they are not written in the manual, not even in the current one. ;)
Forum: RC Jets
11-25-2020, 03:50 AM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

Yes, you are wrong. The dual rx mode for pwm...

Yes, you are wrong. The dual rx mode for pwm output can be set by software only. You have got 7 PWM outputs in single Rx mode and 6 PWM ouputs in dual Rx Mode (the port A is for second Rx input, not...
Forum: RC Jets
11-25-2020, 03:30 AM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

Today I spent some time testing, after a while I...

Today I spent some time testing, after a while I managed to make it work as it should. The setting of the serial in/out mode is confusing, because it is always set as the dual rx mode. In contrast,...
Forum: RC Jets
11-24-2020, 01:40 PM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

OK, thank you. Momo

OK, thank you.
Momo
Forum: RC Jets
11-24-2020, 12:43 PM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

OK, thanks for the quick answer. I understood...

OK, thanks for the quick answer. I understood that they should not be connected together. So which port should be connected to the hub for controlling s.bus servos?
Forum: RC Jets
11-24-2020, 11:51 AM
Replies: 1,019
Views: 274,089
Posted By MomoBrut

I have a question about serial input and output...

I have a question about serial input and output from CP. Only one s.bus receiver is connected. Will the stabilized s.bus signal be exactly the same on both ports 5 and 6? Which of them is suitable...
Showing results 1 to 7 of 7


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.