RCU Forums - Search Results
RCU Forums

Go Back  RCU Forums > Search Forums
Reload this Page >

Search Results

Register
FAQ
Community
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: jeremyilj03
Showing results 1 to 6 of 6
Search took 0.03 seconds.
Forum: Glow Engines
02-10-2019, 06:41 PM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

I finally flew my Ziroli Dauntless with the E999...

I finally flew my Ziroli Dauntless with the E999 radial. It sure did sound amazing and the engine is more than enough power for the Dauntless. I'll take your word that it won't and doesn't need to...
Forum: Glow Engines
01-23-2019, 11:38 AM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

okcrcpilot, The manual for the EVO 999...

okcrcpilot,

The manual for the EVO 999 states 1,000 - 6,000 RPMs as the engine's RPM range. However, it doesn't say if this is on the ground or in the air. I'm accustomed to picking up a couple...
Forum: Glow Engines
01-23-2019, 09:19 AM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

I tried the recommended O.S. carburetor today and...

I tried the recommended O.S. carburetor today and unfortunately it didn't help the engine perform any better (engine continues to run ~ 5100 RPMs). While it did provide more fuel to the engine, I had...
Forum: Glow Engines
01-19-2019, 03:25 PM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

O.S. Carb

Tom,

I just received the new carb that you specified and was surprised to see that it is even smaller than the stock carb in my 999. I take it though that this is nothing to be worried about as...
Forum: Glow Engines
01-11-2019, 05:15 PM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

I ran two tanks through the engine today with the...

I ran two tanks through the engine today with the fuel containing approximately 7% oil (~6% Nitro). I reached 5,300 RPM on average. My 26x10 Mejzlick resulted in the highest RPMs (~5380). All I can...
Forum: Glow Engines
01-09-2019, 01:28 PM
Replies: 2,647
Views: 522,695
Posted By jeremyilj03

I have an Evolution E999 Radial and am unsure if...

I have an Evolution E999 Radial and am unsure if I am getting the proper RPMs out of the engine.

I purchased the engine about three years ago and performed the required break-in about two and a...
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.